Change the Capacitor Value of the Monostable Multivibrator
The 47μF Capacitor replaced by using 100 μF capacitor Resistor Box Value sat to 10 kΩ and pressed the micro switch and start the stop watch simultaneously and measured the length of time for which the LED is ON. Recorded this value and repeat the procedure for two times and took the measurements three times. The readings shown below.
See You with next part.
Laahiru C.Fernando.
The 47μF Capacitor replaced by using 100 μF capacitor Resistor Box Value sat to 10 kΩ and pressed the micro switch and start the stop watch simultaneously and measured the length of time for which the LED is ON. Recorded this value and repeat the procedure for two times and took the measurements three times. The readings shown below.
Now we increased the Capacitor value, so according to the Equation 1: Time constant for monostable multivibrator the time delay increased. If we compare both 100 μF & 47 μF results.
There is increasing resistor value and capacitor value we can get high time delay with our Monostable multivibrator circuit.
We can show it with graph. Graph shown below.
Laahiru C.Fernando.
No comments:
Post a Comment