Open loop power control is the ability of the UE transmitter to sets its output power to a specific value. It is used for setting initial uplink and downlink transmission powers when a UE is accessing the network. The open loop power control tolerance is ± 9 dB (normal conditions) or ± 12 dB (extreme conditions)
Inner loop power control (also called fast closed loop power control) in the uplink is the ability of the UE transmitter to adjust its output power in accordance with one or more Transmit Power Control (TPC) commands received in the downlink, in order to keep the received uplink Signal-to-Interference Ratio (SIR) at a given SIR target. The UE transmitter is capable of changing the output power with a step size of 1, 2 and 3 dB, in the slot immediately after the TPC_cmd can be derived. Inner loop power control frequency is 1500Hz.
Outer loop power control is used to maintain the quality of communication at the level of bearer service quality requirement, while using as low power as possible. The uplink outer loop power control is responsible for setting a target SIR in the Node B for each individual uplink inner loop power control. This target SIR is updated for each UE according to the estimated uplink quality (BLock Error Ration, Bit Error Ratio) for each Radio Resource Control connection. The downlink outer loop power control is the ability of the UE receiver to converge to required link quality (BLER) set by the network (RNC) in downlink.
Power control of the downlink common channels are determined by the network. In general the ratio of the transmit power between different downlink channels is not specified in 3GPP specifications and may change with time, even dynamically.
thanks to http://www.umtsworld.com/
Inner loop power control (also called fast closed loop power control) in the uplink is the ability of the UE transmitter to adjust its output power in accordance with one or more Transmit Power Control (TPC) commands received in the downlink, in order to keep the received uplink Signal-to-Interference Ratio (SIR) at a given SIR target. The UE transmitter is capable of changing the output power with a step size of 1, 2 and 3 dB, in the slot immediately after the TPC_cmd can be derived. Inner loop power control frequency is 1500Hz.
Outer loop power control is used to maintain the quality of communication at the level of bearer service quality requirement, while using as low power as possible. The uplink outer loop power control is responsible for setting a target SIR in the Node B for each individual uplink inner loop power control. This target SIR is updated for each UE according to the estimated uplink quality (BLock Error Ration, Bit Error Ratio) for each Radio Resource Control connection. The downlink outer loop power control is the ability of the UE receiver to converge to required link quality (BLER) set by the network (RNC) in downlink.
Power control of the downlink common channels are determined by the network. In general the ratio of the transmit power between different downlink channels is not specified in 3GPP specifications and may change with time, even dynamically.
thanks to http://www.umtsworld.com/
No comments:
Post a Comment